Thats another small step done. The 120V electrical is done and the 12V is as complete as I can make it without the battery and charger. Everything checks out ok and the best thing … NO SMOKE! Inside the cabin, there are three 12 volt outlets (one in the headboard and two in the upper cabinet) and two 120V outlets (one in the headboard and one in the upper cabinet). In addition, there are two reading lights and an overhead light inside. In the galley, I have one outlet of each type plus an overhead light. The 12V fuse “panel” and 120V breaker box are also located in the galley so I can troubleshoot it if necessary. The next big step will be the insulation.
I also need to decide what tail lights I am going to use. I have a square set that will mount low on the trailer or an oval set that can mount higher in the hatch. If I use the oval set, I will need to run some more wires into the hatch area before I get the insulation in the way.
Update: After a quick sketch, I can tell that I am going to go with the oval lights, they just look better to me.
It is getting closer, but there is still quite a bit on the ToDo list.